Technical Note: The drive does not run at last speed when controller is switched to program mode
The issue is the drive does not run at last speed when the controller is switched to program mode and the drive parameters 30.18 is programmed to “Last Speed”. This can happen with a RCNA-01 (ControlNet), RDNA-01 (DeviceNet) or RETA-01 (EtherNet/IP) installed on an ACx550, ACS800 or DCS800 drive.
RETA-01 Ethernet Adapter's EDS files for DC Drives
EDS files for RETA-01 using for Ethernet/IP protocol and connected to DC Drive DCS800 with firmware 3.5 or higher or to DCS550 with firmware 1.2 or higher.
Please note! the product of DCS800 code has changed from 30 to 300 (since rev. F)!